Cutting sandwich panels and forming openings without damaging the facings
Cutting a panel cuts through the facings and the core at the same time, so the tool must be matched to the whole element. On a new build, the cutting location and its effect on load-bearing capacity are also important. Careful cutting to size helps limit corrections at openings. High temperature and left-over swarf can damage the coating before installation is finished. First check the installation direction, the external side and the required dimension of the finished element. An opening for a window or a service penetration should have an approved location. It cannot be moved to any position simply because it is easier for the installer to work closer to the edge.









